M1907枪带资料分享

followmeya

M1907的枪带看起来安装比较复杂，但实用性比较强。偶在网上收集了些资料来分享一下......



The sling components:

There is a long strap and a short strap. The long strap has two small leather "keeper" loops on it.



Step 1:

Put the short strap through the rear sling swivel so that the metal O ring is nearest the stock and the side of the strap with the hooks is on the outside - with the hooks facing the stock.



Step 2:

Take the end of the long strap that does not have a hook on it and slide it through the O ring on the short strap. Leave one of the leather keepers on the long strap, so its in between the O ring and the metal hooks.



Step 3:

Slide the end of the long strap through the keeper you left on in Step 2. Hook the short strap just below the hook on the long strap.



Step 4:

Put the 2nd sling keeper on the long strap, then slide the end of the long strap through the front sling swivel.


Step 5:

Slide the long strap back through the keeper. Hook the front hook into the long strap.


Completed:

This completes the basic installation of the M1907 sling on the M1 Garand. The same instructions apply to the M1903 Springfield.

The M1907 sling can be loosened and tightened (dressed) on the rifle without unhooking the sling. This can be done by grasping the long strap at the top and bottom and sliding it against itself to loosen or tighten the sling. This portion takes a bit of practice as well as "wear" on the sling. A brand new sling will not move as freely as a well used sling. This simply takes time, oil and use.


By Chris Guska
http://www.90thidpg.us/Equipment/Weapons/M1907Sling/

followmeya

再分享几个演示视频






有个牛人自己做了一条
http://bbs.tiexue.net/post_4081346_1.html

我之前买了条印度产的（估计是仿牛皮）结果味道很大，放了半年才好，当时直接用的话估计会中毒

zqe138

不懂是啥枪，真漂亮。